Aerosol Mold Release 225

Aerosol Mold Release 225

$30.64
AMR-225
  • In Stock: Available for same day shipping if ordered by 12 p.m. (PST)
  • Description: This product is a silicone free, heat stable, non-carbonizing release agent. The heat cured film of 225 does not usually transfer nor migrate so that painting, finishing, bonding, or other secondary processing steps may be accomplished without further treatment. It is thermally stable up to 900 degrees F and is designed for metal or non-metal tools. Manufactured by Lilly Ram.
  • Manufacturer: Lilly-RAM

Choose Options

Quantity
Individual Can
Half Case (6 Cans) [+$150.36]
Full Case (12 Cans) [+$274.47]

Releases: 
Application:
  • Epoxies
  • May be applied over existing release agents.
  • Phenolics 
  • For best results, apply to clean mold
  • Polyimides
  • Apply via spray, brush, or wipe on (ensure rag is fully saturated as to not remove first layer)
  • Polybishmaleimides
  • Apply two coats in opposite directions for optimum results 
  • Polyester
  • Wait 15 minutes before applying the second coat

  • After second coat is applied, bake at 250°F for 60 minutes

  • New tools may require more than 2 coats

  • New tools should be heated to 250°F prior to MR225 application


Removal of Old Release Agent
Scrubbing with metal pads saturated with detergent is the best method for old release agent removal. Follow with a solvent wipe.

Resin Removal
Sanding is recommended for resin removal

Transfer
Should MR225 transfer, use the metal pads, detergent, and solvent wipe. Transfer usually indicates the mold release was too heavily applied.

There are no reviews for this product!

Related Items

Accessories

Recently Viewed Items

PayPal Acceptance Mark

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Top