Black Sanding Gel Coat (5 Gallon Pail)
Black Sanding Gel Coat (5 Gallon Pail)

Black Sanding Gel Coat (5 Gallon Pail)

  • Availability: In Stock and Available for same day shipping if ordered by 11 am (PST)(+/- 3 Business Day Lead Time on topcoat).
  • Description: Lilly Ram Sanding Gel Coat is a low VOC sanding gel coat with a specially formulated resin system designed specifically for post finishing of fiberglass parts. Extremely easy sanding capabilities, even better spraying, and smooth finish. This product meets MACT Standard, EPA 40 CFR Part 63 requirements of the National Emission Standards for Hazardous Air Pollutants.
  • Color Disclaimer: Due to individual user's monitor settings, calibrations and lighting sources, the colors that appear on your screen may not be an exact representation of the actual product. You may purchase a color chart for true color representation at the bottom of this page.
  • Special Handling Fee: This item is considered hazardous in volumes greater than gallon sizes and will include a special handling fee when ordered in individual units with volumes greater than a gallon. If shipped by air, this item will always require a special handling fee, regardless of volume.
  • Manufacturer: Lilly-RAM
  • Size: 1 Gallon

Choose Options

MEKP Catalyst/Hardener (Included at No Cost)
Please Include Catalyst
Catalyst Not Needed
  • VOC content is a maximum of 30%
  • Custom Matches available
  • Special fillers
  • Excellent spray characteristics
  • Lower emissions in the shop
  • Can be custom matched into a wide variety of colors
  • Provides excellent sanding surface ideal for paint, urethanes, enamel and epoxy finishes
  • Minimizes equipment set-up and adjustment

Application: Sanding primer gel coats are not intended to be used as a cosmetic finish. They should not be exposed to direct sunlight and water due to their poor exterior durability. Failure to comply with this warning will result in a rapid color and/or gloss degradation. It is formulated for spraying as supplied. It is strongly recommended that the material be mixed before use. Optimum application temperature is 65°F - 90°F (18°C - 32°C). Apply in several thin, overlapping passes rather than a single heavier coat; this will help avoid porosity, solvent entrapment, and sagging. The recommended wet film thickness is 18 - 25 mils (0.45 - 0.62 mm). Brushing is not recommended. To avoid surface defects in paint application, the surface of the sanding primer must be thoroughly cleaned and sanded smooth with 80–120 grit paper. Sanding dust particles must be blown off with clean compressed air and the surface cleaned with a solvent.

Storage and Handling: Sanding gelcoat should be stored in closed, opaque containers at temperatures above freezing but not exceeding 77ºF (25ºC). Do not keep gel coats near peroxide storage areas. To avoid decomposition keep away from direct sunlight and excess heat. Refer to the Safety Data Sheet for details on safety and storage.

There are no reviews for this product!

Related Items


Recently Viewed Items

PayPal Acceptance Mark

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.